Some tips and notes have to be highlighted when using Taxtrix Openport 2.0 with ECUflash software, otherwise will lead to the flashing and reading ECU failure.
1) Reading or flashing Subaru or Mitsubishi ECU with ECUflash software can only work with Openport 2.0 interface, no other J2534 cables are possible to do this.
2) Plug the Openport 2.0 interface directly into the computer USB port. Do not use any extension cables or converters.
3) Do not turn on the ignition until the ECUflash prompts you to do so. And then quick press ‘OK’, otherwise reading/flashing may fail.
4) Reading and flashing requires you to enter “test mode” by connecting the green diagnostic connector located above the driver’s side foot well (non-CAN models only). Please make sure you vehicle is actually entering test mode with the green diagnostic connectors connected and the Openport 2.0 cable disconnected.
5) Make sure ECUflash is compatible with your Subaru or Mitsubishi model. Check the vehicle model available in Eobd2.fr webpage.
l ANY 2001 and prior USDM Subaru, USDM 2002–2003 non-WRX models, USDM 2004 Impreza RS
l ANY 2000 and prior ADM/EDM/JDM Subaru, 2001–2002 (and some 2003) ADM/EDM/JDM non-WRX/STi models
l ANY Subaru with a diesel engine
5) When your select “read from ecu” in ECUflash or the read icon, a list box will appear from which you must select the correct read method that according to your vehicle. If select incorrect read method, the download will fail.
6) When the system asks for an update, select “NO” and install the software automatically
7) Make sure your car’s battery, charging and electrical system is up to snuff. Reading or flashing ECU will draw power from battery.
留言列表
